El especialista en reparación de fugas de tuberías

Contáctenos

▼ Videos ▼

Descargar

Nuestros clientes

	1°) Surface preparation
	- Preparation Type SA 2 ½ with roughness > 60 microns - Degrease	Material: - Sander / blast - 3X MBX - Degreaser Control: - Preparation uniform - Roughness

	2°) Witnesses repair
	- Place the two witnesses to the two ends of the repair	Material: - 2 metal 3X Témoins - Formwork Control: - Position of witnesses

3°) Winding Kevlar

- Winding with constant tension.

- Leave no 2mm between 2 successive turns.

Material :
- 3X Kevlar

Control:
- No constant
- Voltage of Kevlar

	4°) Installation of formwork
	- Put the formwork - Isolate with PE film and a strip of sticky foam - Perforating module for injecting the resin	Material: - Formwork - PE Film Control: - Set the injection point at the top of the cylinder

	5°) Injection of the resin
	- Inject the resin gradually - Fill the funnel reservoir	Material: - Kevlar Band 3X - Resin 3X - Brushes Control: - No leakage of resin

	6°) Finishing Quality
	- Take a sample of resin - Remove the funnel and strap	Material: - Resin 3X - Painting UV 3X Control: - Hardening of the resin - Recovery of total pipe - Complete tracking sheet *

3X Engineering : 9, avenue Albert II - 98 000 MONACO - Tel : + 377 92 05 79 81 - Fax : + 377 92 05 72 71 - E-mail : 3x@3xeng.com