STOPKiT(range from 4 to 56 inch) is, today, the only efficient repair system applicable under pressure. This unique and revolutionary concept, patented by 3X Engineering, focuses and makes more intense the tightening and compression on the leaking point.
In comparison with a medical compression point, STOPKiTallows to fix a leak very quickly (only few minutes). Its reinforced belt made of Kevlar® sustains temperature dilation without creating more stresses due to weight or strong tightening like traditional metallic clamps make.
STOPKiTcould fix a leak in many different line configurations even on elbows and welds. It is applicable until 80°C with the most common fluids: gas, oil, drinkable water, etc …
STOPKiT IMPLEMENTATION :
1°)STOPKiT preparation
- Joining STOPKiT
- Place the patch in the middle of the strap
Material:
- Torque ratchet 6 to 8 parts
- Recycling bin
Control:
- Fat on the screws, washers
- Diameter of the tube
- Orientation head screws
2°) Preparing the pipe
- Place the two witnesses
at both ends of the repair
Material:
- 2 metal Témoins 3X
- Formwork
Control:
- Position of witnesses
3°) Assembly on the pipe
- Place the patch in the vicinity of the leak
- Tighten allowing freedom of movement
Material:
- Torque ratchet 6 to 8 parts
Control:
- Center the patch on the strap
4°) Stopping the leak
- Drag the markers to STOPKiT
- Screw alternately
- Keep the patch centered
Material:
- Protection PPE
- Key ratchet 8
Control:
- Centering the patch on the leak on the strap
Its permanent version allows the protection and reinforcement of the repair by over-moulding the STOPKiT with a specific shell filled with adapted resin.
In such configuration, the repair resists to external aggression and makes your repair everlasting. In addition this innovative concept avoids any product dismantling or sabotage.
